WhisperKool Platinum Mini Split Wine Cellar Cooling System
System Features: Ultra-quiet and efficient operation Advanced electronic display Liquid bottle probe Energy saving mode Alarm capabilities Flexible installation 55°F temperature differential Condensing unit can be placed outdoors w/optional housing Pump down system for longer compressor life* Low ambient control. BTUh Rating: There are circumstances in which a cellar design may require a larger unit due to some existing design restrictions. There are several factors such as glass, stone, concrete, etc. which will seem adequate but do not offer the insulation capacity required to maintain the optimum environment. We recommend purchasing a unit with a larger capacity to compensate for the design limitations. Please utilizing our Cellar Wizard in order to ensure you are selecting the proper cooling unit for your application. Under sized cooling units can lead to pre-mature failure and/or prevent the system from reaching the desired set temperature. As a result they are not covered under warranty. *Pump down systems are integrated into the design of our split systems to provide our customers with the most professional and reliable split cooling systems for wine cellars. Note: The systems do not include a line set. Cold Weather Start Kit: Introducing the Cold Weather Start Kit by WhisperKOOL. This kit was designed exclusively for our split-systems where the condensing unit will be installed in extremely cold environments. Our split systems are designed to be adaptable to almost any install, as the condensing unit can be located in a variety of locations such as a mechanical room, basement, back yard, or even a rooftop. Our split systems were designed to operate with the condensing unit exposed to temperatures between 20° F and 110° F. However, there are some areas in the country that may drop below 20° F. Due to these conditions WhisperKOOL designed the Cold Weather Start Kit. So, when the outside temperatures drop, the pressure in the system drops as well. This presents a challenge because our systems operate using a pump down cycle and a low pressure switch to turn the compressor on and off. However, when the temperature drops below 20° F the pressure in the system is too low to start the compressor. The use of an electronic bypass is needed to start the compressor and temperature controlled heaters installed on the receiver are needed to raise the pressure in the system to optimal levels. The Cold Weather Start Kit will bypass the low pressure switch on startup and keep the pressure in the system high enough to operate correctly for environments as cold as -15° F. It is important that the cooling system stays operational during cold weather conditions, as heating the house using the central HVAC system will indirectly increase the temperature of the wine cellar. This kit will ensure that the cooling system will continue to operate efficiently in cold weather environments to maintain an optimal wine storage temperature. Option Details: Exterior Housing: The Exterior Housing protects the condenser portion of the split system from the elements when installed outdoors. Active Humidity Option: Our new Active Humidity feature carefully measures the volume of moisture needed to raise the relative humidity within the cellar to the desired level. This design utilizes Intermittent Mist Injection Technology which eliminates the use of pads or filters that can mold over time. Easy to install and effortless in use, simply connect a soft water source to the unit, install the humidistat and you are ready to go. This optional integrated system must be specified at the time of ordering of the unit. For cellars with cooling units already installed, customers can select our stand alone system which offers the same technology in a small, but effective, package. Active Humidity Features: Maintains optimal humidity levels when relative humidity level drops. Intermittent Mist Injection Technology. Included humidistat displays and monitors humidity levels. Specifications: Cellar Size: 500 cu. ft dBA: Evaporator: 51 Decibels Condenser: 65 Decibels Dimensions: Evaporator: 20"W x 10.5"H x 13"D Condenser: 14"W x 10"H x 10"D Weight: Evaporator: 25lbs Condenser: 41lbs AMPS (starting/running): Evaporator: 2/1 Condenser: 11/4 Installation: Evaporator is installed in the cellar, Condenser is installed up to 100 line ft. away Temp. Delta: 55°F temperature differential Thermostat: Digital Control Display Warranty: limited 2 year parts and labor
Specs/Warranty: Manufacturer's WarrantyA limited 2-year/5-year compressor warranty is offered with all self-contained cooling units at their date of purchase. A limited 2-year warranty is offered with all split systems. This warranty does not start or become valid
Manufacturer Part Number: Platinum Mini Split
Custom Stock Status: Made to Order
